Lab Setup

Initial setup of the Access Point

power on the AP. Within five seconds hit enter to stop autoboot. enter factory_reset.

at apboot mode, setenv ipaddr 192.248.4.X setenv netmask 255.255.255.248 setenv gatewayip 192.248.4.Y setenv dnsip 192.248.1.161 saveenv printenv

optional, setenv domainname g1.learn.ac.lk

Then enter boot to load OS image.

Console will show as Init -> Master. This AP will be the master.

Setting up a DHCP server

Password will be admin/serialno Go to DHCP servers menu.

default DHCP scope is for virtual controller assigned networks. It uses private IP ranges only. There are other 3 types of Local DHCP scopes. Local - DHCP and Gateway is at V. controller, Use NAT (This is the NAT mode) Local, L2 - DHCP is at controller but gateway is located outside the AP. (This is just the AP/Bridge mode) Local, L3 - DHCP and Gateway is at V. controller but use forwarding of traffic. (This is the forwarding/routing mode)

IN Local DHCP scopes click new.

Name : WS Type : Local, L2 VLAN :1 Network : 192.248.7.0 Netmask : 255.255.255.0 Default router : 192.248.7.254 DNS : 192.248.1.161 Domain name : ws.learn.ac.lk Lease time : 720

Setting UP SSIDs

login using admin:admin or admin/serialno. Locate Network, Click new. Go through the wizard. 1) Enter ssid, 2) We will assign VC as the DHCP server.

Client IP assignement : virtual controller managed Client VLAN assignment : custom and select the above created(WS).

3) click the slider bar to Enterprise security level, key management : WPA-2 Enterprise Authentication server : new

enter the radius server ip and secret configured in /etc/freeradius/clients Radius IP address : 192.248.1.184

Also make sure AP addresses are added as clients to radius server. 4) keep the network Access unrestricted

Add other Access Points

reset other IAPs and set static IPs. APs in same subnet will be added to the cluster. If there is OS mismatch in new APs will be synced from Master AP and reboot.

Eduroam SSID configuration

login using admin:admin or admin/serialno. Locate Network, Click new. Go through the wizard. 1) Enter ssid, 2) We will assign VC as the DHCP server.

Client IP assignement : virtual controller managed Client VLAN assignment : custom and select the above created(WS).

3) click the slider bar to Enterprise security level, key management : WPA-2 Enterprise Authentication server : new

enter the radius server ip and secret configured in /etc/freeradius/clients Radius IP address : 192.248.1.184

Also make sure AP addresses are added as clients to radius server. 4) keep the network Access unrestricted

Connect to Eduroam SSID

With Laptop With Android

Wi-Fi Infrastructure Maintainance

Firmware upgrade Configuration backup