= VM Installation = ''' Please do not continue if your machine have memory less than 4GB ''' === Setting up VM's === * You may download ova file from [ftp://192.248.6.201/IAM_Appliance.ova ​here]. * Update your Oracle Virtual Box to be the latest from [https://www.virtualbox.org/wiki/Downloads here] * Import them in to Oracle virtual box from File Import Appliance * While importing make sure to Tick reinitialize the MAC address of all your network cards. * This will import two Virtual Machines as IDP and SP. * Before powering on them, please double check your vm network connection to be '''bridged''' with your active network connection and the Promiscuous Mode must set as '''Allow All''' * If all settings are satisfying, power on both Virtual Machines. === Log in to the VM === Login credentials of both VM's are as follows. user: adminiam pass: iam@2018 === Setting UP IP Addresses for IDP === After you start the VM change the IP address. You can find your IDP IP address from [wiki:iam2018/IpAllocation here] Run the commands below to create a new network configuration file {{{ sudo vi /etc/netplan/50-cloud-init.yaml }}} Then you will see the following configuration {{{ # This file describes the network interfaces available on your system # For more information, see netplan(5). network: ethernets: enp0s3: addresses: - 192.248.6.XY/24 dhcp4: false gateway4: 192.248.6.254 nameservers: addresses: - 192.248.6.201 search: - instXY.ac.lk version: 2 }}} Change XY according to the IP address and the search you get from the table. Exit and save your changes by pressing esc and type :wq Restart the VM. Check the connectivity by using the '''ping''' command on some known IP address. === Setting UP IP Addresses for SP === Do the same with SP VM. You can find your SP IP address from here Run the commands below to create a new network configuration file {{{ sudo vi /etc/netplan/50-cloud-init.yaml }}} Then you will see the following configuration {{{ # This file describes the network interfaces available on your system # For more information, see netplan(5). network: ethernets: enp0s3: addresses: - 192.248.6.XY2/24 dhcp4: false gateway4: 192.248.6.254 nameservers: addresses: - 192.248.6.201 search: - instXY.ac.lk version: 2 }}} Change XY according to the IP address and the search you get from the table. > Note that the XY in IP address and search are not the same. Please recheck Exit and save your changes by pressing esc and type :wq Restart the VM. Check the connectivity by using the '''ping''' command on gateway address. Also you need to verify the connectivity to 192.248.6.201 and to fr-training.ac.lk Once both servers have the connectivity, '''ping''' from your host machine to '''idp.instXY.ac.lk''' and '''sp.instXY.ac.lk''' should work. Now you can ssh to the servers and continue with the rest of the installation guide.