Changes between Version 23 and Version 24 of ipv6vmconf

Timestamp:

May 14, 2017, 1:43:22 PM (8 years ago)

Author:

admin

Comment:

--

ipv6vmconf

@@ -7 +7 @@
 The whole setup reside in three VMs. 
 
-1. VM for the Campus LAN (Dynage/Dynamips installed)
+1. VM for the Campus LAN (!Dynage/Dynamips installed)
 2. Two VMs for the Department PCs
 
@@ -26 +26 @@
 === Creating the VM CampusLAN ===
 
- - Start VirtualBox and Click on '''New''' button (at top-right) to create new virtual machine
+ - Start !VirtualBox and Click on '''New''' button (at top-right) to create new virtual machine
  - Enter name of the VM as '''CampusLAN''' 
  - Select OS Type: '''Linux'''
@@ -45 +45 @@
  - On '''Adapter 3''' check the '''Enable Network Adapter''' . Then change '''Attached to be to''' the '''Internal Network''' and give the Name of the network as '''VLAN20'''. This virtual interface will connect to a internal virtual bridged network. 
  - Click on '''Advanced''' drop down list and change the promiscuous mode to '''Allow All'''
-Click '''OK'''
-
-====Adding processors ====
-
+ - Click '''OK'''
+
+==== Adding processors ====
+ - Select the CampusLAN VM from left panel on Virtual box, right click and open '''Settings'''
+ - Click on the '''System''' title
+ - Go to '''Processor''' tab and set processors to '''2'''
+ - Click '''ok'''
 
 === Creating the VM Dept1PC ===