| | 1 | Proxmox Networking: |
| | 2 | |
| | 3 | - Log in to the Proxmox web interface or CLI as a user with administrative privileges. |
| | 4 | |
| | 5 | - Click on the "Datacenter" node in the left-hand pane, then click on the "Network" tab. |
| | 6 | |
| | 7 | - Click on the "Create" button to add a new network interface. |
| | 8 | |
| | 9 | - Select the type of network interface you want to create (e.g., Linux Bridge or Open vSwitch), then provide a name for the interface. |
| | 10 | |
| | 11 | - Configure the network settings for the interface, including IP address, subnet mask, and gateway. You can also configure VLANs and firewall rules at this point. |
| | 12 | |
| | 13 | - Click "OK" to save the network interface. |
| | 14 | |
| | 15 | - Repeat the above steps to create additional network interfaces as needed. |
| | 16 | |
| | 17 | Proxmox Clustering: |
| | 18 | |
| | 19 | - Log in to the Proxmox web interface or CLI as a user with administrative privileges. |
| | 20 | |
| | 21 | - Click on the "Datacenter" node in the left-hand pane, then click on the "Cluster" tab. |
| | 22 | |
| | 23 | - Click on the "Create" button to add a new cluster. |
| | 24 | |
| | 25 | - Provide a name for the cluster and specify the IP address of the cluster manager. |
| | 26 | |
| | 27 | - Create a shared storage volume that all nodes in the cluster can access. This can be done using a SAN, NAS, or other storage device. |
| | 28 | |
| | 29 | - Add additional nodes to the cluster by specifying their IP addresses and joining them to the cluster. |
| | 30 | |
| | 31 | - Configure high availability (HA) settings for virtual machines and containers. This can be done by enabling HA in the settings for each virtual machine or container. |
| | 32 | |
| | 33 | - Configure load balancing settings for the cluster. This can be done by setting up load balancers and configuring the cluster to use them. |
| | 34 | |
| | 35 | - Monitor the cluster for performance and issues using the Proxmox web interface or CLI. |
